Ft. Lauderdale April 19 - 21st, 2017

D-Tools SI Training

 

This 3-Day comprehensive, hands-on D-Tools training course will take you through the D-Tools project lifecycle – we will cover the basics, discuss best practices, and provide market-proven techniques to help you make the most of your D-Tools software investment.

Whether you are just getting started or an experienced D-Tools user, this three day training course will provide you with practical, real-world guidance on building and maintaining your catalog, leveraging packages and project templates to increase efficiency, as well as provide tips and tricks from experienced D-Tools users.

3 Day Course:
$999

Add to Cart

Training Details

Information:

Crestron Design Showroom
1855 Griffin Rd #108, Dania Beach, FL 33004

crestron_logo

Stay at the Courtyard Marriott  when visiting the DCOTA building (just 5 minutes away).

Book your group rate for Creston D-Tools Room Block. Additionally, you can start making reservations by simply calling 1.844.789.2889 and request a reservation under the Creston D-Tools Room Block.

Address: 400 Gulf Stream Way, Dania Beach, FL 33004

Crestron Design Showroom
Design Center of the Americas


(754) 208-5100

Introduction to System Integrator Creating a Proposal
Setup & Configuration Running Reports
Database Entry and Management
Revision Management & Change Orders Visio Elevations
Visio Intro & Line Diagram Visio Floor Plan & Installation Reports
Visio Schematics & Installation Reports Customizing Reports
Scheduling, Service Orders & Mobile Install D-Tools and QuickBooks

Crestron Design Showroom Design Center of the Americas